Show Vlt 1. Dell EMC S4182 OS10Stack ID and interface for second peer didn't Z9432-1# show vlt 1 Domain ID : 1 Unit ID : 1 Role : primary Version : 3.1 Local System MAC address : e8:b5:d0:92:3e:6b Role priority : 32768 VLT MAC address : e8:b5:d0:92:3e:6b. He mentioned something about expired x509 cert, could you check by running #show vlt 1 vlt-port-detail to see if it sheds any light to the issue.
132F0005 Danfoss Danfoss Inverter Drive, 1.5 kW, 1 Phase, 230 V ac, 6 from in.rsdelivers.com
Make sure that Peer-Routing is set to Enabled.The VLTi Link Status and VLT Peer Status must both be up. primary-priority 1; Configure VLT on second switch using interfaces 25 and 26 using: vlt-domain 1 backup destination 1.1.1.1 discovery-interface ethernet1/1/25-1/1/26 peer-routing primary-priority 2; After this the VLT status should be up which can be validated with show vlt 1 Example output Domain ID : 1
Syntax show vlt id role Parameters id - Enter the VLT domain ID, from 1 to 255 1-65535 (highest to lowest) Force10(conf-vlt-domain)# back-up destination 1.1.1.2 (primary peer) Force10(conf-vlt-domain)# back-up destination 1.1.1.1 (secondary peer) Specify the management IP address of the peer switch The show vlt command shows the VLT details for the VLT domain entered
Trajeto de VLT passa por construções de diferentes épocas no Centro. He mentioned something about expired x509 cert, could you check by running #show vlt 1 vlt-port-detail to see if it sheds any light to the issue. I created the below scenario to see what would happen if you created a situation where RSTP can forward from S2 across both port 11 and port 12 to get to interface VLAN 1 on switch 3
Linha do VLT começa a funcionar às 06h RJ1 G1. The show vlt domain_id command validates the VLT configuration status OS10# show vlt 1 Domain ID : 1 Unit ID : 1 Role : primary Version : 1.0 Local System MAC address : 90:b1:1c:f4:xx:xx VLT MAC address : 00:11:22:33:44:55 IP address : fda5:74c8:xxxx:1::1 Delay-Restore timer : 1000 seconds Peer-Routing : Disabled Peer-Routing-Timeout timer : 0 seconds VLTi Link Status port-channel1000 : up VLT Peer Unit ID System.